Boiling Water - Silvercrest SWKG 3000 EDS B2 Bedienungsanleitung

Boiling water

RISK - ELECTRICAL SHOCK!
► Never place the electrical base
potentially fatal risk!
WARNING - RISK OF INJURY!
► For safety reasons you should not open the lid when the water is boiling or
extremely hot. There is a risk of scalding.
WARNING - RISK OF INJURY!
► Always use freshly drawn water. Do not consume any water that has
already stood in the kettle for longer than one hour. Do not reboil water
that has cooled down. Always pour old water away. Microbes could have
formed in it!
NOTE
► Always ensure that the ON/OFF switch
plug is unplugged and the device is standing on the base
If not, the device could heat up unintendedly as soon as the mains plug is
plugged in again.
1) Lift the kettle off of the base when filling it!
2) Press the unlocking button
NOTE
► When filling it, hold the kettle upright. This is the only way to read the
markings on the scale
3) Fill the kettle...
–
–
4) First close the lid, then place the kettle on the base
on the base
5) Now insert the plug into the mains power socket.
6) Press the ON/OFF switch
7) The control lamps integrated into the scale
ON/OFF switch
8) As soon as the water is boiling, the appliance will switch itself off, the
ON/OFF switch
SWK 3000 EDS B2
correctly.
to at least the MIN mark, so that the appliance does not overheat,
to maximum the MAX mark, so that boiling water cannot spill out.
.
indicate that the appliance is now heating up.
clicks upwards and the light goes out.
close to water – this would be a
is turned to " " when the mains
and open the lid.
downwards so that it engages.
as well as the control lamp in the
.
, so that it sits securely
GB
19