Knife With Smooth Edge; Knife With Serrated Edge; Scissor Sharpening; Flat-Head Screwdriver - Silvercrest SEAS 20 A1 Bedienungsanleitung

• After sharpening, remove any possible grinding remnants that may be on
the blade with a moist cloth.

Knife with smooth edge

If you have selected the setting "Knife with smooth edge"
• Always sharpen knives with a smooth edge on both sides – for this, left
and right side sharpening guides are available.
• In the left guide hold the knife inclined to the left, and in the right guide
inclined to the right, whilst drawing the blade through.

Knife with serrated edge

If you have selected the setting "Knife with serrated edge"
• Sharpen these only on the side with the serration – the draw through
direction for the knife is dependant on which side of the blade this is on.
The side with the serrated edge must be pointing in the direction of the
grindstone
t
• In general, serrated blades can only be sharpened up to a point. Knifes
with a fine sawtoothing (e.g. table knives) do not require sharpening.

Scissor sharpening

If you have selected the setting "Scissor sharpening"
• Sharpen both scissor blades one after the other. For this, open the scissors
out and draw both blades, one after the other, through the guide.

Flat-head screwdriver

Should you wish to grind a slot-screwdriver
• This is possible in every position of the function and protective cap
Appropriate to its width, insert the screwdriver through one of the two grin-
ding openings
end face of the screwdriver will now be ground level and flat.
during sharpening.
on the front of the function cap (see fold-out side). The
r
e
flat (Fig. E):
r
- 46 -
(Fig. B):
q
(Fig. C):
w
(Fig. D):
y
.