Switching On And Off / Setting The Speed Range; Advice On Working With Materials / Tools / Speed Ranges - Parkside PFBS 10.8 A1 Bedienungs- Und Sicherheitshinweise

Operation
P ress the spindle lock
I nsert the collet
18
tighten the clamping nut
the combination key
NOTE: Use the screwdriver end of the combi-
nation key to release or tighten the screw of
23
the mandrels .
13
Switching on and off / Setting
Q
the speed range
Switching on / Setting the speed range:
S et the ON / OFF switch
S et the rotational speed control
between „1" and „MAX.".
Switching off:
S et the ON / OFF switch
Setting the appropriate speed
Symbols Material
Rotational
speed
control
1
Plastics and low melting
1–3
point materials
Stone, Ceramics
4–5
5 Softwood, metal
Examples of appropriate tool selection Function
Function
Drilling
Milling
Engraving
Polishing,
derusting
CAUTION!
Use only the lightest
contact pressure of
the tool on the work-
piece.
14 GB/IE
and keep it pressed.
8
into the threaded insert and
on the thread using
6
.
23
to position "I".
5
to a position
1
to position "0".
5
Accessory
HSS drill
12
Milling bits
21
Engraving bits
20
Metal brush
16
Polishing wheel
14
Advice on working with
Q
materials / Tools / Speed ranges
U se the highest speed when working on steel
or iron with the milling bits.
U se a short trial on a test piece to determine the
optimum rotational speed range for working on
zinc, zinc alloy, aluminium, copper and lead.
U se the low speed range for working on plastics
and low-melting point materials.
U se high speeds on wood.
U se the medium speed range for cleaning,
polishing and buffing.
The following information shall be considered as
recommendatory only. Learn by practical experience
which tools and settings are the best for the materi-
als you work with.
Hardwood
6–7
Steel
Max
Application
Drilling wood (see Fig. C)
Various tasks, e.g. hollowing out, gouging,
shaping, grooving or slotting
Markings (see Fig. D)
Derusting (see Fig. E)
Working on various metals and plastics, in
particular noble metals like gold or silver
(see Fig. F)