AEG BE8715001 Bedienungsanleitung Seite 28

28 www.aeg.com
The direction in which you open
the door depends on your oven
model. You open the door from
the right side in some models
and from the left side in others.
Removing the oven door and the glass panels
Clean the door with a wet sponge and
rub it dry with a soft cloth. Do not use
steel wool, acids or abrasive cleaning
agents because they can damage the
surface.
Installing the door and the
glass panels
When the oven door is clean, install the
glass panels in the opposite sequence.
The middle glass panel has a small dot
on the top and the second one has
screen printings. Make sure that you put
the middle glass panel in the correct
seats.
1.
A
2.
B
Press the buttons at the sides of the
door trim (A) on the upper cover and
pull it upwards to remove it.
Hold the inner glass B tightly with
both hands and slide it upwards to
remove it from its initial position. Do
the same with the second glass pan-
el.
CAUTION!
Make sure that you tightly hold
the glasses to prevent them from
falling.
The screen-printing zone must face the
inner side of the door. Make sure that af-
ter the installation the surface of the
glass panel frame is not rough when you
touch it.