BOMANN GS 195 Bedienungsanleitung Seite 25

Problem Problem Problem Problem Possible cause Possible cause Possible cause Possible cause
The appliance is Are the ventilation openings clear of ob-
not working struction?
properly or at all.
The content is - Is the temperature setting correct?
not cold enough. - Was the appliance door open for an
extended period?
- Was large quantity of food placed in
the appliance within the last 24 hours?
- Is the appliance near a heat source?
Loud noise dur- Is the appliance not leveled vertically and
ing operation. horizontally?
Water on the Is the temperature setting correct?
bottom.
The housing The refrigeration cycle takes place in the foaming. The heat exchangers are installed in
becomes warm- the housing covered. The appliance cut the interior heat, which must be dissipated
ly. through the housing areas.
Water on the On days of high humidity, condensation might occur on the outer surface of the appli-
outer surface. ance. This is no malfunction; you may simply wipe the water off.
NOTE: NOTE: NOTE: NOTE:
If a problem still persists after following the steps above, please contact your trader or an authorized
technician.
Solution Solution Solution Solution
Unblock the ventilation openings, install the
appliance freely.
- Check the temperature setting.
- Open the door only as long as necessary.
- Adjust a colder temperature.
- Check the installation location (see "In-
stallation").
Adjust the feet accordingly. Liquid flow
sounds in the cooling circuit are normal.
Check the temperature setting.
25