Before First Use - IKEA LAGAN DW60 Handbuch

ENGLISH
2. Press Program. The end indicator comes
on. The acoustic signal for the end of
programme is activated.

Before first use

1. Make sure that the set level of the water
softener agrees with the water hardness
in your area. If not, adjust the water
softener. Contact your local water au-
thority to know the water hardness in
your area.
2. Fill the salt container.
Adjusting the water softener
German
degrees
(°dH)
47 - 50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
1) Default setting.
2) Do not use salt at this level.
How to adjust the level of the water
softener
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to "Setting
and starting a programme".
2. Press and hold Program until the pro-
gramme indicator
the programme indicator
with fixed light.
Water hardness
French mmol/l
degrees
(°fH)
84 - 90 8.4. - 9.0
76 - 83 7.6 - 8.3
65 - 75 6.5 - 7.5
51 - 64 5.1 - 6.4
40 - 50 4.0 - 5.0
33 - 39 3.3 - 3.9
26 - 32 2.6 - 3.2
19 - 25 1.9 - 2.5
7 - 18 0.7 - 1.8
< 7 < 0.7
starts to flash and
comes on
3. Press the on/off button to deactivate the
appliance and to confirm the setting.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Processing residues can stay in the ap-
pliance. Start a programme to remove
them. Do not use detergent and do not
load the baskets.
Clarke
degrees
58 - 63
53 - 57
46 - 52
36 - 45
28 - 35
23 - 27
18 - 22
13 - 17
5 - 12
< 5
3.
Wait until the programme indicator
goes off. The programme indicator
continues to flash. The end indicator
starts to flash. The intermittent flashing
of the end indicator refers to the current
set level.
• E.g. 5 flashes + pause + 5 flashes =
level 5.
4. Press Program again and again to
change the setting. Each time you press
Program the level number increases.
Water softener
adjustment
Level
10
9
8
7
6
1)
5
4
3
2
2)
1
8