Before First Use - IKEA LAGAN AA-2189603-3 Bedienungsanleitung

ENGLISH
3. Press Previous or Next to change the
value.
4. Press OK to confirm the setting.
• The new setting is saved.
• The appliance returns to the setting
selection.
5. Press and hold simultaneously
for about 3 seconds to exit
setting mode.

Before first use

1. Make sure that the current level of the
water softener agrees with the
hardness of the water supply. If not,
adjust the level of the water softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start the programme Quick 30' to
remove any residuals from the
manufacturing process. Do not use
detergent and do not put dishes in the
baskets.
After starting the programme, the appliance
recharges the resin in the water softener for
up to 5 minutes. The washing phase starts
only after this procedure is complete. The
procedure is repeated periodically.
The salt container
Caution! Use rough salt designed
for dishwashers only. Fine salt
increases the risk of corrosion.
The salt is used to recharge the resin in the
water softener and to assure good washing
results in daily use.
The appliance returns to the programme
selection.
The saved settings remain valid until you
change them again.
and
Filling the salt container
1
3
Put 1 litre of water in
the salt container
(only for the first
time).
2
4
Put 1 kg of salt in the
salt container.
15