Removing The Drawer; What To Do If - AEG 47056IU Benutzerinformation

To install panels, do the above steps in
the opposite sequence.
11.4 Oven lamp
WARNING!
There is a danger of electrical
shock!
Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or
switch off the circuit breaker.
Put a cloth on the bottom of the
oven for protection of the oven
light and glass cover.
Replacing the oven lamp
1. You can find the lamp glass cover at
the back of the cavity.
Turn the lamp glass cover counter-
clockwise to remove it.
2. Clean the glass cover.
3. Replace the oven lamp with applica-
ble 300°C heat-resistant oven lamp.
Use the same oven lamp type.
4. Install the glass cover.

11.5 Removing the drawer

The drawer below the oven can be re-
moved for cleaning.

12. WHAT TO DO IF...

WARNING!
Refer to the Safety chapters.
2. Pull the door trim to the front to re-
move it.
3. Hold the door glass panels on their
top edge one by one and pull them
upwards from the guide.
4. Clean the door glass panels.
1. Pull the drawer out until it stops.
2. Lift the drawer at a small angle and
remove it from the drawer support
rails.
Inserting the drawer
1. Set the drawer on the support rails.
Make sure that the catches engage
correctly into the rails.
2. Lower the drawer until it is horizontal
and push it in.
WARNING!
When the oven is in use, heat can
build up in the drawer. Do not
keep flammable things in there
(e.g. cleaning materials, plastic
bags, oven gloves, paper, clean-
ing sprays, etc.).
ENGLISH
31
2
1