Display Connection; Display Operation - Faytech 1500 Bedienungsanleitung

Components:
1. Auto-display setting: the display is automatically adjusted to the
current resolution of your graphics card
2. MENU: open the OSD menu –or- confirm selection in the OSD menu
3. +: increase volume –or- navigate in the OSD menu –or- change the
highlighted values in the menu
4. -: decrease volume –or- navigate in the OSD menu –or- change the
highlighted values in the menu
5. PWR: turn the display on or off
6. Infrared receiver
7. VGA connector to PC and to display (15)
8. USB connector to PC and to display (16)
9. 120 or 220V adaptor connects to input (14)
10. 120 or 220V power plug
11. Driver CD
12. Touch pen
13. User's guide
14. 12V DC power input
15. VGA connector
16. USB Connector
17. 3.5mm audio in

Display Connection

Each cable is labeled for easy connection. To operate your faytech display
properly, there must be at least one signal source and a power supply
connected. If you have the optional touch screen and you want to use it, you
also must have the USB port connected to your PC.
To connect the , you have the following options:
1. signal source
On a PC: Connect the VGA cable from the faytech monitor to the VGA output of
l
your PC graphics card.
On a PC: If you have only one DVI output on your PC, please purchase a DVI
l
to VGA adapter and connect the display via VGA to your PC.
In addition, the display has one stereo audio input (3.5mm audio in).Audio
comes through the speakers only if there is an image signal.
.Connect power using only one of these options (do not try to connect more
2
than one power source at the same time):
32 faytech Ltd. 2009
C
Display Connection
You can connect the faytech display with the included 120V/220V plug or the
12V power adapter. Insert one of these power sources into the input (14)
which is labeled +12 VDCIN (found on the back side of the display).
If you use another power source, please make sure to connect the inside pole
to a positive 12V source and connect the outside pole to a ground on the same
power source. Make sure you connect to a power supply that delivers +12 V
DC and 4 A.
Connect the USB cable (on one end of the All-In-One cable) to the USB port
3.
on your PC (only for the display with touch function) but only after you are
requested to do so while you are installing the touch software.

Display Operation

For a description of the buttons on the display see the previous section titled
1.
"Components".
The remote control: The remote control functions are similar to the buttons
2.
on the display. Before using the remote for the first time, please remove the thin
plastic on the back side so that the battery makes contact and the remote
control has power.
OSD-Menu-Operation in VGA mode: The Menu operation of the faytech
3.
display is simple and logical. You have three control buttons. MENU, +/ -.
Pressing MENU brings up the OSD menu; with +/- you can navigate through the
main menu. By pressing MENU again you switch to the submenu. Use +/- to
select the appropriate item in the submenu. The selected item will be marked in
red. To change the value of an item please use +/ –. Press MENU again to save
the changes and you can then navigate again with the + and - buttons. To
return to the main menu, select EXIT and press MENU.
OSD-Menu-Operation in AV mode: The Menu for either AV signal has almost
4.
the same tabs and functions as when in VGA mode. The "Picture Settings" tab is
not available. The "Auto Calibration", "Auto Color" and "Color Temperature"
functions under "Color Settings" are replaced with "Saturation" and "Hue".
33