Display Connection; To Connect The Signal Source; Connect To Power; Using The Touch Function - Faytech 12.1 Bedienungsanleitung

DISPLAY CONNECTION

To operate your faytech display properly,
there must be at least one signal source
and a power source connected. To use
the touch function please connect the
USB cable to your PC.
TO CO NNECT THE SIGNAL
SOURCE
you have the following options:
On a PC: Connect the VGA cable from
the faytech monitor to the VGA output
of your PC graphics card.
 On a PC: you have only one DVI
output on your PC, please purchase a
DVI-VGA adapter and connect the
display via VGA to your PC.
22": you also have DVI, HDMI and
video inputs to connect the image signal,
please ensure that you are on the right
channel (channel-switch through INPUT)
In addition, the display has one stereo
audio input (3.5mm Audio-IN). The
sound through the speakers is output
only if an image signal is there.

CONNECT TO POWER

You can connect the faytech display
with the included 110V/220V power
adapter, please put it into the mounted
socket on the underside of the display
which is labeled with +12 V DC IN.
Approach to connect to another 12V
source: Please note to use a power
supply with min. 2.5A and ensure that
the polarity is right (+ on the inside
pole).

USING THE TOUCH FUNCTION

Connect the USB cable to the USB port
on your PC (after you have been asked
within the software installation
process).
The touch-screen series also supports
the use of touch through the serial port
(15" to 19" touch-monitors). Please
connect a serial cable (not included in
delivery) to use the serial touch
function.

DISPLAY OPERATION

OSD-MENU-OPERATION

The Menu operation of the faytech
display is simple and logical. You have
three control buttons. MENU, +/ -.
Pressing MENU brings up the OSD menu;
with +/- you can navigate through the
main menu. By pressing MENU again
you switch to the submenu. Use +/- to
select the appropriate item in the
submenu. The selected item will be
marked in red. To change the value of an
item please use +/ –. Press MENU again
to save the changes and you can then
navigate again with the + and - buttons.
To return to the main menu, select EXIT
and press MENU.
37