Connection With The Mains; Operation - EuroLite LED D-25 Beam Effect Bedienungsanleitung

dimensioned and used correctly in accordance with the latest industrial safety regulations (e. g. BGV C1,
BGI 810-3).
Please note: for overhead rigging in public or industrial areas, a series of safety instructions have to be
followed that this manual can only give in part. The operator must therefore inform himself on the current
safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Pull the safety bond through the attachment eyelet and over the trussing system or a safe fixation spot.
Insert the end in the quick link and tighten the safety screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already held the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
Before taking into operation for the first time, the installation has to be approved by an expert!

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the effect to the mains, the LED D-25 Beam Effect starts running.
You can do without a controller as the device features a built-in microphone, which provides automatic sound
control. You can adjust the microphone sensitivity with the rotary-control on the rear panel.
With the Mode-switch you can set Auto or Sound Control Mode:
Sound Control Mode: The internal program is controlled by sound.
Auto Mode: The internal program runs automatically.
You can adjust the program speed with the rotary-control on the rear panel.
With the Strobe-switch you can set Strobe Mode on or off. Strobing is functional in Sound Control as well as
in Auto Mode.
DANGER TO LIFE!
International
L
N
15/16 00085429, Version 1.0