Herunterladen Inhalt Inhalt Diese Seite drucken

Charging The Batteries; Tone (Dtmf) Or Pulse Dialling; Fitting The Belt Clip - AUDIOLINE DECT 5500B plus Bedienungsanleitung

Schnurloses digitales dect-telefon
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Important notice: Place the handset on the base station or charger, with the display
facing forwards, for at least 16 hours. If the batteries are not properly charged, the
telephone may fail to function correctly. While the handset is charging, the battery
capacity symbol in the display will blink. The
is placed in position.
2.6

Charging the batteries

The rechargeable batteries in your handset provide for a maximum standby time of 350
hours and a call time of up to 14 hours.
The actual state of charge of the batteries is shown in the display:
Full
If the remaining charge in the batteries is too low, the symbol in the display will blink
and you will hear a warning peep every 10 seconds.
To charge the batteries, place the handset on the base station or charger with the display
facing forwards.
Notice: Before using the telephone for the first time, the batteries must be charged for
at least 16 hours. Like your car battery, the rechargeable batteries suffer from a certain,
unavoidable ageing effect. You can, however, minimise this by exercising the batteries
correctly. As you use your telephone, always start with fully charged batteries and
continue using it until they are "empty" as indicated by the blinking
display. Then recharge them fully. This will maintain maximum battery capacity for as
long as possible. Repeated partial charging and discharging will "teach" the batteries to
operate with reduced capacity.
2.7

TONE (DTMF) or PULSE dialling

This forward-looking feature enables you to operate your telephone on both the older
analogue lines (pulse dialling) and the newer digital lines (tone/DTMF dialling). The
equipment is factory set for TONE dialling (DTMF). If your AUDIOLINE DECT5500+ fails
to function on your line, consult point 7.7 to learn how to set your telephone for PULSE
dialling.
2.8

Fitting the belt clip

Slide the belt clip into the grooves until it audibly clicks home.
- Setting Up -
indicator lights as soon as the handset
Half
Low
symbol in the
41

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis