Charging The Standard Batteries; Dtmf Or Pulse Dialling; Fitting The Belt Clip; Setting The Time And Date - AUDIOLINE DECT 5600 SMS Bedienungsanleitung

3.5

Charging the standard batteries

The standard rechargeable batteries for your telephone have a stand-by time of max.
350 hours at room temperature and a maximum talk time of up to 14 hours. If the
battery capacity is too low, the symbol will flash in the display and you will hear warning
tones every 10 seconds. To charge the standard batteries, place the handset in the base
station with the display to the front. The current battery capacity is shown in the display
in several steps.
Full
Notice: Before using the telephone for the first time, the batteries must be charged for
at least 16 hours. Like your car battery, the rechargeable batteries suffer from a certain,
unavoidable ageing effect. You can, however, minimise this by exercising the batteries
correctly. As you use your telephone, always start with fully charged batteries and
continue using it until they are "empty" as indicated by the blinking
display. Then recharge them fully. This will maintain maximum battery capacity for as
long as possible. Repeated partial charging and discharging will "teach" the batteries to
operate with reduced capacity.
3.6

DTMF or PULSE dialling

This forward-looking feature enables you to operate your telephone on both the older
analogue lines (pulse dialling) and the newer digital lines (DTMF dialling). The equipment
is factory set for TONE dialling (DTMF). If your phone fails to function on your line,
consult point 9.7 to learn how to set your telephone for PULSE dialling.
3.7

Fitting the belt clip

Slide the belt clip into the grooves until it audibly clicks home.
3.8

Setting the time and date

The display shows the date and the current time. The time and date must be reset when
setting up the telephone for the first time, if the standard batteries become completely
discharged, after restoring the factory settings or after switching off.
1. Press the
2. Select the Setup menu by pressing
3. Confirm the Time setting function with
4. Now enter the current date (Example 2 7 0 7 for 27
5. Now enter the current time (Example 1 6 4 0 for 16:40 hours) and confirm with
.
- Setting Up -
Half
button.
Low
and confirm with
.
th
July) and confirm with
symbol in the
.
.
47