Making The Connections; Connecting Signal Sources; Connector Configuration; Column Module - Omnitronic ASS-1023 Bedienungsanleitung

6

MAKING THE CONNECTIONS

Switch off the PA system and the units to be connected before making or changing the connections.

Connecting Signal Sources

1
A microphone can be connected via XLR or 6.3 mm plug at the input MIC, both balanced and
unbalanced.
2
Audio units with line level (e.g. mixer or CD player) can be connected via balanced and unbalanced
XLR or 6.3 mm plugs at the input LINE or via the unbalanced RCA L/R input.
A good cable run improves the sound quality remarkably. Signal cables should be short and direct, since
high frequencies will mostly be absorbed if cables are unnecessarily long. Besides that a longer cable may
lead to humming and noise trouble. If long cable runs are unavoidable, you should use balanced cables. In
order to obtain highest sound quality, only use high-quality cables for connecting the devices. Make sure that
the cables are properly fixed.

Connector Configuration

Column Module

Connect the column speaker to the speaker connector of the
subwoofer using the included connection cable. For locking
the connection turn the plug to the right. For unlocking pull the
unlock button and turn the plug to the left and pull it out of the
socket.

Connection to the Mains

Finally, connect the supplied power supply cable to the corresponding input and the mains plug to an outlet
(AC 230 V, 50 Hz). The device can also be operated with AC 115 V, 60 Hz ~. For this purpose, set the
voltage selector switch to the 115 V position.
17