Installation - Omnitronic ASS-1023 Bedienungsanleitung

1 MASTER control for the overall volume
2 POWR/LIMIT indicator
Lights up blue as power indicator and red when the signal level is too high; the limiter will reduce
the signal level to protect the speakers.
Reversal switch PHASE
3
Selector switch for the phase between subwoofer signal and column speaker signal.
• Switch engaged: the phase is turned by 180°
• Switch disengaged: the phase is identical
4 Volume control LEVEL for the subwoofer
5 Volume control LINE for the line input
6 Volume control MIC for the microphone input
7 Microphone input
Balanced combo input (XLR/6.3 mm jack) for connecting a microphone.
8 Line input
Balanced combo input (XLR/6.3 mm jack) and unbalanced RCA L/R input for connecting audio
units with line level (e.g. mixer, CD player).
Always use one of the inputs at a time.
SATELLITE OUT speaker connector
9
Speaker jack for connecting the column speaker.
10 Voltage selector switch
11 Fuse
Only replace the fuse when the device is disconnected from mains. Only use fuses of the same
rating and power. The correct fuse value is specified on the rear panel.
12 Power input
Plug in the supplied power cable here.
13 Power switch
..............................................................................................................................................................................
5

INSTALLATION

The speaker systems can be mounted to a satellite system with the included telescope bar. For this, insert
the bar into the flange on the upper side of the subwoofer; then fasten the column module on top. The
column module's lower speakers should be at ear's height; adjust the telescope bar accordingly.
• Always install the speakers at a solid, plane, anti-slip, vibration-free, oscillation-free and fire-resistant
location. Before installing the system, make sure that the installation area can hold a minimum point load of
5 times the system's load (e.g. weight 20 kg - point load 100 kg). The speakers must never be installed
higher than 100 cm without secondary attachment.
• Satellite systems must only be installed on a plane area with a maximum inclination angle of 5°.
• The stand has to be installed out of the reach of people. An unintended movement of the load has to be
avoided - also in case of fire!
• Depending upon the individual installation spot, all necessary measures against movement and for
securing the standing safety have to be taken.
16