Making The Connections; Connector Configuration; Connection To The Mains - Omnitronic VFM 208AP Bedienungsanleitung

6

MAKING THE CONNECTIONS

Switch off the speaker system and the units to be connected before making or changing the
connections.
1
Audio units with line level (e.g. mixer or CD player) can be connected via the unbalanced RCA L/R input
LINE INPUT.
2
A microphone can be connected via XLR or 6.3 mm plug at the input MIC INPUT both balanced and
unbalanced. Models 212AP and 215AP have two microphone inputs.
3
At the RCA output LINE OUTPUT the master signal of all channels is available. This output allows
connecting e.g. the input of another active speaker system for additional PA applications.
A good cable run improves the sound quality remarkably. Signal cables should be short and direct, since
high frequencies will mostly be absorbed if cables are unnecessarily long. Besides that a longer cable may
lead to humming and noise trouble. If long cable runs are unavoidable, you should use balanced cables. In
order to obtain highest sound quality, only use high-quality cables for connecting the devices. Make sure that
the cables are properly fixed.

Connector Configuration

Connection to the Mains

Finally, connect the supplied power supply cable to the corresponding input and the mains plug to an outlet.
23