KKT KOLBE GS6013ED Benutzerhandbuch Seite 66

Troubleshooting
Problem
Foam in in the drain.
Spots on the inner
wall
The dishes are not
quite dry.
The dishes and the
pans are not clean.
Spots and streaks on
the lenses and the
pans.
Steam.
Black or gray spots
on the plates.
Water on the bot-
tom, inside of the
device.
Leaks in the dish-
washer machine.
30
Possible causes
Rinse aid poured out.
Dishwashing detergent
with dye
The rinse aid dispenser is
empty.
Wrong program.
Incorrect insert.
• Extremely hard water
• Low input temperature
• Incorrect insert
• Wrong detergent
• Wrong salt /
detergent
Normal appearance.
The rubber on the alumi-
num cutlery touches the
plate.
Normal appearance.
The detergent dispenser
is filled over or the deter-
gent pours into the interior
of the device.
The dishwasher is not
balanced.
Help
Wipe excess or poured out rinse aid always
immediately
Use detergent without dye.
Fill up on this.
Select a more intensive wash program.
Make sure that the spray arms and the de-
tergent dispenser are covered with no great
dish pieces.
See related sections of this manual for the
determination of whether the detergent,
salt and detergent levels are fine. Verify
whether the dishes are loaded properly.
The drying and draining of water can result
in the leakage of a small amount of steam in
the vicinity of the door latch.
To eliminate these stains, use a medium-ab-
rasive cleaners. In the future, always make
sure that the harness is correctly inserted.
A small amount of water on the floor of the
unit is normal.
Do not over fill the detergent dispenser.
The poured detergent may cause excessive
foaming and overflowing. Wipe all poured
liquids immediately with a damp cloth.
Make sure that the dishwasher is horizontal
and is balanced.