Replacing The Fuse; Technical Specifications - EuroLite TS-2 Bedienungsanleitung

Replacing the fuse

If the lamp burns out, the fine-wire fuse of the device might fuse, too. Only replace the fuse by a fuse of
same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rearpanel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.

TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
DMX-control-channels:
DMX-512-connection:
Sound-control:
PAN-movement:
TILT-movement:
Number of colours:
Number of gobos:
Dimensions (LxWxH):
Weight:
Maximum ambient temperature t
Maximum housing temperature t
Fuse:
Accessories
OMNILUX EFP 12V/100W GZ-6.35 50h
OSRAM EFP 64627HLX A1/231 12V/100W GZ6.35
OMNILUX EFP 12V/100W GZ-6.35 500h
EUROLITE DMX Operator 192 Kanal
EUROLITE DMX Scan Control 192 Kanal
EUROLITE DMX Scan Pilot 192 Kanal
Wizard-512 USB DMX-Software + Interface
Wizard-1024 USB DMX-Software + Interface
Please note: Every information is subject to change without prior notice. 26.01.2006 ©
230 V AC, 50 Hz ~
115 W
5
3-pin XLR
via built-in microphone
within 130°
within 90°
12 colours, 2 bicolor-filters and white
12 gobos, open and shutter
295 x 195 x 290 mm
4 kg
: 45° C
a
(steady state): 60° C
B
F 1 A, 250 V
No. 88285005
No. 88285010
No. 88285105
No. 70064520
No. 70064525
No. 70064530
No. 51860102
No. 51860110
29/54 51785765_V_1_4.DOC