Operation - Cloer 4120 Gebrauchsanweisung

Preparation for use
·
Remove all packaging elements and labels, but
not the rating plate.
·
Place the electric kettle on a dry, even, non-slip
surface.
Before initial use
·
EN
Please read these operating instructions
carefully before using the device for the first
time.
·
shake out the water from the first boiling
process.
Safety notices for use of the
contact base / electric kettle
The appliance meets the
requirements of the applicable
EC directives.
The appliance is intended for in
door use only.
·
Do not fill the electric kettle with water past the
MAX marking. Scalding may result from water
boiling over.
·
Always remove the electric kettle from the
contact base before filling with water.
·
This electric kettle may only be used for heating
water.
·
Use the electric kettle only with the provided
contact base.
·
Before operating the machine, make sure that
the contact base is dry.
·
Please make sure that water is never spilled on
the contact base.
·
If water is accidentally spilled onto the contact
base, proceed as follows:
– Unplug the unit from the wall socket.
– Dry the contact base with an absorbent
dry kitchen towel.
– Dry the surface beneath the contact base.
– Plug the unit into the wall socket again.
·
Never operate the electric kettle without
the lid closed and without lime filter, since
then the device will not shut off automatically
when the water boils.
CAUTION!
The surface is hot during
operation. Only touch the device
at its handle.
ATTENTION!
Always unplug appliance when
not in use and before cleaning!

Operation

·
Plug the power plug into the wall socket.
·
Remove the electric kettle from the contact base.
·
Open the lid of the removable kettle by pressing
the button to open the lid.
·
8 NOTE: For your safety, the lid is equipped
with a locking device. If the electric kettle
is accidentally overturned during use, the lid will
not open. This reduces the risk of being scalded
by spilled water.
·
Fill the electric kettle with water.
·
close the lid manually.
·
MAKE SURE not to fill water past the MAX
marking (4110/4111= 1,7l, 4120/4121 = 1,2l) on
the water level display.
·
Place the electric kettle anywhere on the contact
base. The unit is now ready for operation.
·
To switch it on, press the ON/OFF switch
on the bottom of the handle. The switch locks
into place and the control lamp lights up.
·
After boiling process the electric kettle
automatically switches off.
·
You can interrupt the boiling process at
any time by pushing up the ON/OFF switch.
·
IMPORTANT: Always make sure that the device
is switched off before removing the electric
kettle from the contact base.
Overheating protection device
The electric kettle is equipped with a double-
action overheating protection device. In the
event that you accidentally operate the electric
kettle without water or if the water level is too
low, causing the water to evaporate during
boiling, the device will automatically switch
off for your safety. The device will be ready to
operate once it has been filled with cold water.
Cleaning
·
CAUTION: The appliance must not be immersed
in water! Do not clean the electric kettle with
heavily abrasive cleaners. They could scratch
the appliance.
·
clean very dirty appliances with a damp cloth.
Removing / cleaning the lime
filter
·
The lime filter is located below the pouring
spout inside of the kettle (Fig. 1).
1
·
To remove, press the upper flat edge with your
thumbs to release the two brackets (Fig.2). Then
remove the filter towards the top.
3
2