Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mounting
Important notes
¯ To prevent damage to electronic components, only mount/remove the device with the voltage supply
switched off.
¯ The mounting location always must correspond to the operating conditions specified in the technical
data. If required, take additional measures.
¯ In the installation space, continuous and sufficient air circulation is absolutely required to dissipate the
heat of the device. The ventilation slots must not be covered.
¯ When selecting the installation site, be sure to observe an ergonomic position of the screen and pay
regard to the incidence of light, which may cause reflections on the screen.
¯ During installation, there is a danger that the device will fall out of the mounting cutout. You should
therefore secure it to prevent this happening until all screw clamps have been fitted.
¯ During mounting, the gasket of the front frame is exposed and can be damaged.
– Handle the gasket with care during mounting.
– Protect the gasket against ultraviolet rays.
– Check the gasket to make sure it is undamaged before you install the device.
¯ The device must be securely seated in the mounting cutout and the front panel seal must be correctly
fitted. Otherwise, class of protection IP65 will not be achieved on the front side of the device!
Dimensions
Panel PC
V80GAP...
¯
Lenze
MA_v800−c
2.0
d
b
338 (13.3")
353
391 (15.4")
426
546 (21.5")
567
Mounting
b1
h
[mm]
332 ±1
261
392 ±1
303
532 ±1
369
10
h1
e1
240 ±1
51
269 ±1
55
334 ±1
55
EV800A007
e2
e3
12
2 ... 13
11
IP65: >3
11
Werbung
Inhaltsverzeichnis
