Remote Control Operation; Dmx-Controlled Operation; Addressing - EuroLite LED BC-7 Beam Effect with Dot Effect Bedienungsanleitung

Remote control operation

1
When actuating a button, always hold the remote control in the direction of the sensor. There must
be visual connection between the remote control and the sensor.
2
The device must be set for remote control. Hold the remote control in the direction of the sensor and
press the IR button. If data is received, the LED display will flash briefly.
3
The remote control is supplied with a battery inserted. An insulating foil between the battery and the
battery contacts prevents the battery from being discharged during storage. Prior to the first
operation remove the foil from the battery support on the rear side of the remote control. Otherwise
operation of the remote control is not possible.
4
If the range of the remote control decreases (8 meters as a maximum), replace the battery. For this
purpose, on the rear side of the remote control press the small bar with the
groove to the right and at the same time remove the battery support. For
operation, one 3 V button cell type CR 2025 is required. When inserting,
pay attention that the positive pole of the button cell shows upwards in the
support.
Danger of explosion when battery is replaced improperly. Only replace by the same type.
Please dispose of old and used batteries properly. Batteries are hazardous waste and should

DMX-controlled operation

You can control the devices individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. Individual DMX channels and their features are listed under DMX
Protocol.

Addressing

The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the LED BC-7 Beam Effect will respond to the controller.
Please, be sure that you don't have any overlapping channels in order to control each LED BC-7 Beam
Effect correctly and independently from any other fixture on the DMX-chain.
If several LED BC-7 Beam Effects are addressed similarly, they will work synchronically.
Slave function
DMX, default 001
Dow n / decrease
Flash mode
Fade mode
not be disposed of with regular domestic waste!
AUTO mode
Remote function
Color change
UP/ increase
Speed control
CAUTION!
22/24 00085014.DOC, Version 1.0