Mounting Instructions; Mounting The Unit - Ground Zero GZDSP 6-8X Anleitung

•
As a precaution, it is recommended to disconnect the vehicles battery before mounting (also note the vehicles manual!)
•
The power supply wire (+12 V) has to be protected within max. 20 cm / 8" by a main fuse holder with matching fuse value
(Main fuse value has to be equal to the sum of values of the fuses of each connected device)
•
If necessary, replace a defective fuse with the identical value only
•
Never drill a hole to the vehicles gas tank or brake lines, to wirings or any other important vehicle part!
•
Never pass wires over sharp edges or vehicle parts
•
Keep the wiring away from the antenna and electronic devices contributing to radio reception
•
Lay the power supply wiring always separated from speaker wiring
• The unit should not be mounted on a heavily vibrating part or surface (e.g. subwoofer enclosure)
•
If a pre-amplified output (RCA) is available (at the head unit), it is recommended to use it for input wiring
•
screwdriver
•
electric drill - 3 mm / 0.12" carbide drill bit
•
power and ground wiring (min. 1.0 mm² / 17 AWG)
High powered audio systems in a vehicle can generate "Live Concert" levels of sound pressure. Continued exposure
to excessively high-volume sound levels may cause hearing loss or damage. Also, operation of a motor vehicle while
listening to audio equipment at high volume levels may impair your ability to hear external sounds such as horns,
warning signals or emergency vehicles! This may lead to potential traffic hazards. In the interest of safety, consumer
Before starting to install the unit, please consider the following:
- if you are planning to expand your system by adding other components in the future, ensure enough space is left
and cooling requirements are met.
- if your head-unit is equipped with pre-amplified outputs (RCA), we recommend using them.
You may use the unit as a template to mark the mounting holes, then remove it and drill the marked holes. Finally mount the unit with the
mounting screws.
Choose a mounting position where all electric wires are protected from being damaged by sharp edges, heat or other conditions. +12 Volt
DC electrical connections must be fused on the battery side. Make sure your head-unit and all other devices will remain turned off while
connecting parts of the system. If it is necessary to replace any fuse make sure to use only an equivalent one. Using inferior fuses may cause
serious damage to your unit, system or even your cars wiring. Any kind of damage traced back on disregard of these notes will not be
covered by the warranty!

Mounting instructions

Required parts and tools for the installation
electronics recommends listening at lower volume levels while driving.
Selecting a mounting position

Mounting the Unit

WARNING!
Caution
- 3 -