Montage - ABB i-bus EIB Montageanleitung

- 9 -

Montage

Zum Einbau in Verteiler.
Schnellbefestigung auf Tragschienen 35 mm,
DIN EN 50 022.
Der Anschluß an den Bus erfolgt durch Auf-
schnappen auf die Tragschiene mit einge-
klebter Datenschiene.
Important notes
These operating instructions contain the
necessary information for the correct use of
the aforementioned unit in an installation bus
system EIB.
Detailed descriptions of the user programs and
documentation on planning support by the
manufacturer are available for planning and
configuring the bus units in an installation bus
system EIB.
Standards and regulations
The relevant standards, guidelines, speci-
fications and regulations of the country in
question must be observed for planning and
setting up electrical systems.
- 13 -
- 10 -
Important notes
Work on the installation bus may only be
carried out by trained electricians. The bus line
and the units must be installed and connected
in accordance with the relevant guidelines,
observing the EIB user manual Building Sy-
stems Engineering of the national EIBA.
The relevant safety regulations, e.g. accident
prevention regulations, law on technical work
equipment, must also be observed for the
connected equipment and systems.
- 14 -
- 11 -
Mounting and Operating Instructions
h
GB
ABB i-bus EIB
Choke
Type DR/S 2.2
Instr.-no. GH Q600 7027 P0001
ABB STOTZ-KONTAKT GmbH
Postfach 101 680, D-69006 Heidelberg
Telephone (06221) 701-543, Fax (06221) 701-724
Important notes
Safety instructions
- Protect the unit against moisture, dirt and
damage during transport, storage and
operation.
- Do not operate the unit outside the
specified technical data.
- Operate only in a closed housing
(distribution cabinet).
- Earth the unit at the terminals provided
for this purpose.
- Do not obstruct cooling of the units.
- 15 -
- 12 -
Connection diagram
Technical data
Isolates the bus line from the power supply.
With reset button for freeing up the bus bus
line and resetting the connected bus devices.
Is used in conjunction with the SV/S 30.320
power supply unit and for feeding a further
line with the SV/S 30.640 power supply unit.
Input/Output
rated voltage 29 VDC, +/- 1V, SELV
rated current 0,5 A
Ambient temperature
operation - 5 °C to + 45 °C
Operating and display elements
LED red reset
switch reset, freeing
- 16 -