Service; General Inspection; Battery Disposal - Westfalia ASBS 18 Originalbetriebsanleitung

WARNING: If the power tool gets excessively hot in use, stop using the
tool immediately and allow cooling before continuing work. The cooling
period can be reduced by operating the tool at maximum speed with no
load. Always make sure the motor vents (6) are not blocked and do not
allow dust to enter the body of the tool through the motor vents; dust,
especially metallic dust, may damage or destroy the tool.

Service

WARNING: Always disconnect from the mains power supply, before
carrying out any maintenance/ cleaning of the charger. Remove the
battery before carrying out any maintenance/cleaning of the tool.
Note: Both the tool and the charger contain no user-serviceable parts.
If the device does not perform as outlined in this manual, turn to the
Westfalia customer service or to a competent professional.

General Inspection

 Regularly check that all the fixing screws are tight.
 Inspect the supply cord of the charger for damage or wear prior to
each use. Repairs should be carried out by an authorised service
centre. This advice also applies to extension cords used with this
tool.
Lubrication
 Slightly lubricate all moving parts at regular intervals with a suitable
spray lubricant.

Battery Disposal

1. Run motor until the battery is completely discharged.
2. Remove the battery from the tool.
3. Wrap heavy insulating tape around the battery terminals or enclose
in a sealable plastic bag to prevent possible shorting.
4. Dispose of the battery through your local waste removal authority.
Operation
26