JVC KD-BT1 Bedienungsanleitung Seite 50

Symptom
• Correct characters are not displayed (e.g.
album name).
• While playing a track, sound is sometimes
interrupted.
• The sound is interrupted or skipped during
playback of a USB device.
• Bluetooth device does not detect the unit.
• The unit does not detect the Bluetooth device. • Check the Bluetooth setting of the device.
• The unit does not make pairing with the
Bluetooth device.
• Echo or noise occurs.
• Phone sound quality is poor.
• The sound is interrupted or skipped during
playback of a Bluetooth audio device.
• The connected audio device cannot be
controlled.
48
Remedy/Cause
This unit can only display letters (capital: A – Z,
small: a – z), numbers, and a limited number of symbols.
The tracks have not been properly copied into the USB
device. Copy tracks again into the USB device, and try
again.
• Turn off, then turn on the unit.
• (When the sound is not yet restored,) connect the device
again.
The unit can be connected with one Bluetooth cellular
phone and one Bluetooth audio device at a time.
While connecting a device, this unit cannot be detected
from another device. Disconnect currently connected
device and search again.
• Search from the Bluetooth device. After the device
detects the unit, select "Open..." on the unit to connect
the device. (See page 17.)
• Enter the same PIN code for both the unit and target
device. If the PIN code of the device is not indicated on
its instructions, try "0000" or "1234."
• Select the device name from "Special Device," then try to
connect again. (See page 18.)
• Try to pair/connect from the Bluetooth device.
• Check if your Bluetooth device support the respective
profile. (See page 16.)
Adjust the microphone unit position.
• Reduce the distance between the unit and the Bluetooth
audio device.
• Move the car to a place where you can get a better signal
reception.
• Reduce the distance between the unit and the Bluetooth
audio device.
• Disconnect the device connected for "Bluetooth Phone."
• Turn off, then turn on the unit.
• (When the sound is not yet restored,) connect the device
again.
Check whether the connected audio device supports AVRCP
(Audio Video Remote Control Profile).