Adjusting The Sound; Storing Your Own Sound Modes - JVC KD-BT1 Bedienungsanleitung

Adjusting the sound

You can adjust the sound characteristics to your
preference.
• When appears on the display, you can move
back to the previous display by pressing number
button 3.
1
2
• For "EQ" setting, see the following.
3
Adjust the selected setting item.
A
Fad/Bal (Fader/Balance)
1
Press number button 1 (
to the "Fad/Bal" adjustment display.
2
Adjust the speaker output balance by
pressing:
5 ∞
/ : between the front and rear
speakers. [F06 to R06]
4 ¢
/
right speakers. [L06 to R06]
B
Subwoofer
1
Press number button 1 (
to the "Subwoofer" adjustment display.
4
2
Use
frequency to the subwoofer.
• 80Hz: Frequencies higher than 80 Hz
are cut off.
• 120Hz: Frequencies higher than 120 Hz
are cut off.
• 160Hz: Frequencies higher than 160 Hz
are cut off.
3
Turn the control dial to adjust the
subwoofer output level. [0 to 8]
C
VolAdjust, [–5 to +5]
Turn the control dial to adjust the input level
of each source (except FM).
Adjust to match the input level of the FM
sound level.
34
) to move
: between the left and
) to move
¢
/ to select a cutoff
• Before making an adjustment, select a
source you want to adjust.
D
Loudness, [Off or On]
Turn the control dial to select "Off" or
"On." When "On" is selected, low and high
frequencies sound are boosted to produce a
well-balanced sound at low volume level.
4
Exit from the setting.

Storing your own sound modes

You can adjust the sound modes and store your own
adjustments in memory.
• When appears on the display, you can move
back to the previous display by pressing number
button 3.
1
Follow steps 1 and 2 on the left column.
• In step 2, select "EQ."
2
Select a sound mode.
3
Select a frequency range.
4
Adjust the sound elements of the
selected frequency range.
5 ∞
1
Use / to adjust the level.
2
Press number button 2 (
the control dial to select the frequency.
3
Press number button 2 (
the control dial to select the band width.
To display the rest
), then turn
), then turn