Menu Screen Setting; Switch Setting; Operation - JVC KA-HD250 Bedienungsanleitung

3.
Connecting a Monitor
Prompter video (RM-P210 [AUX VIDEO INPUT] terminal
input signal) from RM-P210 can be verified by connecting
this device's [PROMPTER OUTPUT] terminal located in
the front to a monitor using a BNC cable.
MEMO
• Power for this device and the camera are supplied by
RM-P210 via the 26 pin camera cable.
• 26 pin camera cable
VC-P110 (5 m)
VC-P112 (20 m)
VC-P113 (50 m)
VC-P114 (100 m)

Menu Screen Setting

1.
Output Signal Setting
Composite video signal is always output from the RM
multi-pin connector. In addition, RGB component, Y/P
P component or YC separate signal can also be output.
R
Select the output signal using the OUTPUT item on the
SYSTEM menu screen.
MEMO
Sync signals are superimposed onto RGB component sig-
nals.

Switch Setting

1.
Enabling/disabling INCOM MIC
Set the [INCOM MIC ON/OFF] switch depending on
whether headset microphone will be used. Set the switch
to [ON] use the headset microphone.
/
B
INCOM MIC
ON/OFF switch

Operation

1.
Turn the RM-P210 on.
Turn the [POWER] switch of the camera remote control
unit to [ON]. CALL button lights up green when the power
is turned on. After the [POWER] switch is turned on, cam-
era remote control unit can be operated after about 30
seconds.
MEMO
After the power is turned on, the camera remote control unit
takes about 30 seconds to be ready to communicate with
this device.
2.
Press the [CALL] button.
Press and hold down the [CALL] to send call signals to
the remote control unit operator. The [TALLY] button indi-
cator of the remote control unit blinks.
[CALL] button indicator changes from green to red while
the button is pressed. The [TALLY] lamp on the view-
finder also blinks when call signals are received from the
remote control unit.
3.
Adjust the volume.
Adjust the headset reception volume with [INCOM
LEVEL].
MEMO
• If both this device (including the camera) and the remote
control unit have the same functional switches, the
remote control unit switches are prioritized.
• If external synchronization signal is present when the
power is turned on, pictures may appear choppy for a
few seconds. This is not a malfunction.
• When using the remote control unit, refer to its instruc-
tion manual for details.
CALL
button
INCOM LEVEL
volume
13