Heizplatte entfernen.
Bestell Nr.
BP 336 536-T
3 Stück
Eingetrocknete Heizplatten-Kontaktpaste
entfernen.
VORSICHT
Neue Heizplatte und Anpressplatte
müssen plan aufliegen.
Heizplatte und Gehäuseboden gleichmässig
mit Heizplattenkontaktpaste (BN845295-T)
einstreichen.
Heizplatte auf Gehäuseboden legen und
durch Links- Rechtsbewegungen
Kontaktpaste verteilen.
Gewinde des Befestigungsbolzens mit
Gewindeschmiermittel (B2596701-H)
einstreichen.
Anpressplatte auf Heizplatte legen und mit
Scheibe und Mutter handfest montieren.
Mutter mit Drehmomentschlüssel (100 Nm)
nachziehen.
Diffusionspumpe in umgekehrter Reihenfolge
zusammenbauen.
42
Remove heating plate.
Remove encrusted heater contact paste.
Make sure the new heating plate and
the pressure plate are seated
absolutely flat.
Apply contact paste (BN845295-T) evenly on
heating plate and the bottom of the housing
Place the heating plate on the housing bottom
and look for the optimum position using
left/right movements.
Coat the thread of the holding bolt with thread
lubricant (B2596701-H).
Put the pressure plate on the heating plate,
mount it finger tighten using washer and nut.
Tighten the nut with torque wrench (100 Nm).
Reassemble the diffusion pump by performing
the above steps in reverse order.
PDA501-W / PDB501-W
Order No.
BP 336 536-T
3 pieces
CAUTION
DIF05deHSR (201605)