Leckey Squiggles Benutzerhandbuch Seite 9

Attaching the
footplate
If you have ordered a footplate we
recommend that you attach it first.
You will need the multi tool and spanner
which are supplied.
To attach the foot plate first set the seat base
upside down on a secure surface at working
height. Hold the foot plate support stem in
place and push the socket bolt provided
through the hole in the side. Feed it through
the holes and set on the securing nut,
tightening the socket cap bolt a couple of
turns to hold it in place.
Next, use the spanner to hold the nut and
tighten the socket cap bolt using the multi
tool. Do not over tighten them as this needs
to be free to allow the footplate and stem to
be angled.
Finally fit the adjustment lever. To do this
feed the cup square bolt through the slot and
hole. Set on the washer and hand lever.
Tighten the bolt clockwise a couple of turns
to start it on the thread. Then push the bolt
into the slot and tighten the hand lever. You
will have to tighten half a turn at a time. To
do this turn the hand lever half a turn
clockwise, then lift the lever and rotate it
back half a turn like this. Keep turning back
and forward until it is secure.
Always make sure the footplate is
firmly attached.