Attaching The Back Rest - Leckey Squiggles Benutzerhandbuch

Attaching the
back rest
To attach the backrest, slide the backrest tube
into upright receiving tube at the back of the
product, then tighten the knob (A) securely.
Attaching the
push handle
The push handle is attached to both the
Hi Low chassis and the Easy Chassis by
inserting the two lower stems into the
receiving tubes as shown. The push handle
has safety poppers, which need to be
pressed in when inserting the lower stems.
On the Hi Low chassis push the stems in until
the poppers protrude from the other end of
the receiving tubes.
On the Easy chassis the popper will engage
in a hole in the receiving tube. Once inserted
secure the push handle by tightening the two
hand knobs (B) underneath.
Check the knobs are tight before youmove
the product, particularly if you are moving
the seat unit along corridors that may have
uneven or sloping surfaces.
A
B
B