Leckey Squiggles Benutzerhandbuch Seite 10

Attaching the seating system to the
Hi Low or the Easy Chassis
Adjust the height of the chassis to its
maximum to reduce risk of back strain while
attaching the seat unit. Refer to section 10
on how to adjust the height of the chassis
you have purchased.
First release the safety locking pin at the
front of the seat. To do this pull the pin out
and rotate through 90 degrees. Carefully lift
the seat and place it into the chassis. At the
rear of the underside of the seat you will see
a receiving channel. Place this securely over
the tube towards the back of the chassis.
Pull the handle at the front of the seat unit up
and then pivot the seat forward and down.
Once the front of the seat is lowered fully,
release the handle and push it forward to
ensure it has fully engaged on the front tube.
Rotate the safety locking pin (A) so it
engages in front of the handle. If it hits the
handle then the seat is not inserted properly,
remove and repeat process outlined above.
Always check the handle and locking pin
are fully engaged before you place the
child in the seating system. If the handle
is not engaged properly the seat unit can
come loose and could cause serious
injury to the child or carer.
A