VOLTCRAFT Ir 1200-50D USB Bedienungsanleitung Seite 45

Additionally, the corresponding alarm function with the symbol "Hi" or "Lo" is displayed.
Confirm your input with "MODE" or push the measuring button (5). The settings are saved.
While measuring, a signal sounds when the corresponding alarm level is exceeded. The associated symbol "Hi" or
"Lo" starts to flash in the display.
The set alarm values are retained after deactivation.
Data transfer USB interface
The meter is equipped with an USB interface to transfer and store the measured values on a computer.
To connect the infrared thermometer to your computer, proceed as follows:
Start your computer with the operating system Windows® XP or higher.
Insert the enclosed software CD into a CD drive and follow the instructions on the screen.
If the automatic programme installation does not start, select the CD drive in Explorer and start the installation
programme "setup.exe" manually. Follow the instructions on the screen.
After successful installation of the programme, install the USB driver manually as well. For this, choose the CD drive
in Explorer and open the folder "USB Driver". Start the installation programme "cp210xVCPInstaller.exe" manually.
Follow the instructions on the screen.
Activate the USB interface in the system setting menu "Set", sub-item "Send Data" at the meter.
If required, activate the continuous measurement function to prevent automatic deactivation during possible measur-
ing breaks. The data transfer only takes place with the meter activated.
Open the lateral cover (1) at the meter. Plug the enclosed USB cable into the lateral mini USB socket and connect
the other end of the cable to a free USB interface on your computer.
The computer will automatically recognise a new device. After successful installation, you can start the measuring
software.
If the data connection has been established, "Connected" is displayed.
45