switel bdt800 Bedienungsanleitung Seite 92

To use the functions described here, you need
S
the handset,
S
the alarm unit
S
and the DTMF programming unit, subsequently referred to as programming unit.
DTMF=Dualtone Multi-Frequency
INFORMATION ON PROGRAMMING
q
S
Press on the alarm unit to cancel a process during programming.
#
S
Press on the programming unit to confirm a setting.
S #
Press again to exit from Programming mode.
S
To program the unit, hold the programming unit above
the handset microphone. Otherwise, it may not receive
the keytones properly.
Note: When programming, maintain a clearance of at least 1 m between the handset and alarm unit and lower the volume setting of the alarm
unit. Otherwise, interference noise could be produced which affects programming.
92
Alarm Unit