Connecting The Telephone - Swissvoice CP100 Bedienungsanleitung

Connecting the telephone

There is a general concession to switch-on the telephone. Therefore, you can connect
it yourself under the following conditions:
• The appliance is only intended for connection to an analog telephone network, the
analog port of a telephone system or an Internet telephony adapter.
• The telephone does not require its own power supply.
• Connect the receiver cable with the telephone receiver and the other end to the
jack on the left side of the telephone.
• Use the telephone connecting cable to connect the telephone to the telephone
socket or the connection to the telephone system.
Wall assembly
Measure and mark the holes for the wall assembly in accordance with the underside of
the telephone.
Make sure that no cables run in the vicinity of the drilling point (electric, telephone,
antenna, water or heating). If you are not sure, choose another assembly location or,
using an applicable measuring device, check for possible existing cables.
Use appropriate screws, the heads of which fit into the mountings on the base of the
telephone.
Hang the telephone on the slightly protruding screw heads.
Check to see if the telephone can easily slide upwards. If yes, then remove the tele-
phone and turn in the screws a little further. Place the telephone on the screws again
and, as necessary, repeat the procedure.
Note
It is possible that black colouring/stripes appear on the surface because of the rubber
feet on the underside of the telephone. If you want to prevent this, we recommend that
you place something appropriate between the wall and telephone.
Swissvoice CP100
Swissvoice CP100
3