Setting The Dialling Method; Use Of The Analog Port Of Internet Telephony Adapters; Appendix; Care - Swissvoice CP100 Bedienungsanleitung

Swissvoice CP100

Setting the dialling method

• Use the switch at the rear of the telephone to set the desired method of dialling (T =
Tone dialling/MFV / P = Pulse dialling/IWV). For connection to the analog telephone
network, please set the switch to T (Tone dialling/MFV).

Use of the analog port of Internet telephony adapters

When using the Internet telephony adapter, seldom problems can occur with the rin-
ging signal.
However, the Swissvoice CP100 is not defect.
The following can be the cause of incorrect operation:
• The deviation of the signals transmitted to the telephone by the adapter, used for
converting Internet telephony to analog telephone (for the most part supplied by the
provider), is too far out of the tolerance range for correct operation of the tele-
phone.
In such contingencies, as far as possible, please check the Swissvoice CP100 on an
analog landline connection, for comparison and/or contact your provider for Internet
telephony.

Appendix

Care

Your telephone is a product that fulfills high demands in design and construction. The-
refore, it should be treated with care.
Observe all of the safety instructions on Page 1.
Clean the telephone with an anti-static cloth, or slightly moist soft leather cloth and
subsequently with a dry cloth.
6 Swissvoice CP100