General Information - Siemens SIMEAS P Betriebsanleitung

2.2

General Information

These operating instructions include the information re-
quired for proper use of the corresponding products. These
operating instructions are intended for technically qualified
personnel with sufficient competence and knowledge in the
areas of instrumentation and control engineering, which will
be referred to as automation engineering throughout the
rest of these operating instructions.
In order to ensure safe installation and commissioning, as
well as safe operation and maintenance, all personnel
should fully understand and comply with all safety informa-
tion and warnings contained in this document in a techni-
cally correct manner. Only personnel who meet the re-
quirements outlined in Chapter 2.3 for qualified personnel
possess the expertise and knowledge required to apply the
general safety information and warnings of this document
correctly for each specific and individual scenario.
While these operating instructions are included with the
product, it is important to note that not every aspect of the
product, nor every possible installation, operation and main-
tenance scenario, can be thoroughly discussed.
If more information is required, or if specific problems arise
which are not discussed in this document, additional infor-
mation can be requested from your local Siemens subsidi-
ary or from the address given on the back cover of this
document.
45