Standard And Guidelines; Approval; Safety Regulations And Warnings; General Notes - Siemens AR6181-MS Betriebsanleitung

1

Standard and Guidelines

1.1

Approval

1.2

Safety regulations and warnings

1.3

General notes

Siemens Building Technologies
Fire Safety & Security Products
If used according to the instructions, this radio system meets the basic require-
ments of article 3 and the remaining applicable conditions of the R&TTE directive
(1999/5/E6) of March 1999.
The unit must only be used for the purpose intended by the manufacturer.

The operating instructions must be kept to hand and made available to every

user.
Unauthorized changes and the use of spare parts and accessories which are not

sold or recommended by the manufacturer of the unit could cause fire, electric
shock or injury. Therefore, such measures will result in a renunciation of liability
and the manufacturer will not accept any guarantee claims.
The manufacturer's guarantee terms in the version valid at the time of the sale

are applicable to the unit. No liability will be accepted for unsuitably or incorrectly
set parameters – whether automatic or manual – or for inappropriate use of the
unit.
All repairs must be carried out by the manufacturer.

The user is responsible for ensuring that the unit is set up and connected in ac-

cordance with the recognized technical regulations in the country of installation
and any other guidelines valid in the relevant region.
Before opening the unit, always switch off the power supply and take measure-

ments to ensure that there is no power to the unit.
If an operating display goes out, this does not necessarily mean that the unit is

disconnected from the mains and has no power. If you are working on an open
device, remember that live components may be exposed.
The ID-card readers AR6181-MS and AR6182-MS (with keypad) are new proximity
ID-Card readers in a Square housing, part of the Access reader range. The read-
ers read proximity ID-card of 13,56MHz technologies like Mifare
Access Reader Design has been created as a simple device for standard flush-
mounting boxes and for simple adjustment. For wall-mounting a distance frame
and for all models an accessory pack is part of delivery.
The identification card readers are connected via the door controller CC30xx to the
CerPass, via dual reader interface DRI to SiPass integrated, via eight reader inter-
face ERI to SiPass integrated or via door controller DC2000 / K24 to SIPORT NT
Access control system. The readers AR6181-MS and AR6182-MS (with keypad)
Standard and Guidelines
®
. The new Square
02.2010
5