Enabling The Alarm - Silvercrest SWE 100 B1 - IAN 73607 Bedienungsanleitung

Enabling the Alarm

After the desired alarm time has been set, you can enable the alarm as
follows:
 Press the AL.ON/OFF button [3]. The indication "ALARM" [30]
appears on the display.
 To disable the alarm, press the AL.ON/OFF button [3] again. The
indication "ALARM" [30] disappears.
 The device will power on at the set alarm time and will receive the last
tuned-in frequency and frequency band.
 Press the AL.ON/OFF button [3] to switch the device off. To disable
the alarm, press the AL.ON/OFF button [3] again.
 or
 Press the SNOOZE button [6] to delay the alarm for approx. 5
minutes. After this delay, the device will power on again.
Even when the alarm function is enabled, you can use
the device as usual. However, remember that the device
always powers on with the last tuned-in frequency and
frequency band as well as the last volume setting.
The alarm function will work only if the device has been
powered off previously.
Multi-Band Tuner SWE 100 B1
English - 125