Sewing In Zips; Sewing In A Drawstring - Medion MD 17187 Bedienungsanleitung

Sewing
66 of 122
 At the end, you are advised to set the stitch length to "0" and sew a few
more stitches so that the threads are better connected and the buttonhole
does not fray so quickly.
 Then use the knife provided to cut the fabric between the seams. Do this
carefully to ensure you do not damage any of the bartacks.
TIP
Pin a safety pin in front of the top bartack to stop you cutting through it.

6.13. Sewing in zips

Presser foot: .............................................................................................. Zip presser foot
Programme: .......................................................................................................................... 1
Stitch length: ................................................................................................................1 to 4
Depending on which side of the zip band you are sewing, the presser foot
must always be on the fabric.
For this reason, the presser foot is attached on either the left-hand or right-
hand side, and not in the middle like all other presser feet.
 Raise the presser foot and needle (26) to their top position to change the
presser foot.
 Place the zip on the fabric and place the workpiece in position under the
foot.
 To sew on the right-hand side of the zip, attach the zip presser foot so that
the needle (26) sews on the left-hand side (1).
 Sew the right-hand side of the zip, creating the seam as close as possible to
the teeth. (1)
 Sew in the zip around 0.5 centimetres below the teeth using a bridge.
 To sew on the left-hand side of the zip, change the foot position on the
presser foot holder (29).
 Proceed in the same way as for the right-hand side of the zip (2).
 Before the foot reaches the slider on the zip band, lift the foot up and open
the zip, keeping the needle (26) in the material (3).

6.13.1. Sewing in a drawstring

You can also use the zip presser foot to sew in drawstrings, as shown in the il-
lustration.
 Fold the fabric over once to create a drawstring tunnel and then sew along
the drawstring, making sure the zip presser foot is behind the drawstring.