Difrnce R200 Anleitung Seite 50

Then:
If the screen displays either:
Or:
Then the network is using one of the encryption systems: Wired Equivalent Privacy (WEP) or Wi-Fi
Protected Access (WPA). You therefore need to enter the correct WEP or WPA code into the radio
to get it to communicate with your network.
Only the person who set up the network in the first place knows this code; if that person is not you
then you need to find out what it is.
After 3 seconds, the display goes into the code entry mode. To enter the code, use the knob to
select each character of the code in turn, pressing the SELECT button after each character. Note
that WEP and WPA codes are sensitive to upper and lower case characters so you must enter
them exactly.
Use the BACK button to erase incorrect characters.
After the final character, use the knob to select the END character and press the SELECT button.
The radio should now be able to connect to the network.
If the display shows "Invalid key" or "Network Error", an incorrect password has probably been
entered.
15
Network OK
Enter WEP key
Enter WPA key