Steps For Connecting Your Radio To Your Wireless Network; Step 1-Power Up The Radio; Step 2 - Scan For A Wireless Network Connection - Difrnce R200 Anleitung

Steps for connecting your radio to your wireless network

Step 1-Power up the radio

First, connect the AC power. In use, the radio can be switched on or off with the standby button,
The display on the front of the radio will light up and say:
Reciva Radio ARM Powered
After a few seconds, this will change to show:
Initialising Network
After a few seconds, this will change to show:
< Scan for networks >
Enter network
View Config
Edit Config
Step 2 – Scan for a wireless network connection
When the display says<Scan for networks>, press the SELECT button.
(Note: if you make a mistake at any point, press the BACK button to go back to the previous
screen.)
The radio will now scan for all available wireless networks and will display:
Scanning
13