Configure Menu; Choosing The Option You Want From The Configure Menu - Difrnce R200 Anleitung

Configure menu

Choosing the option you want from the Configure menu

1. Press the SELECT button.
(Note: if you make a mistake at any point, press the BACK button to go back to the previous
screen.)
2. Turn the knob until 'Configure' is displayed
3. Press the SELECT button.
4. Turn the knob until the display shows the option you want.
5. Press the SELECT button to choose the option shown on the display. The options are explained
below.
<Network Config>
Enables you to scan again for connection to another wireless network, or to manually configure
the network parameters. Use this if you take the Internet radio to another building where you
want to use it.
<Version>
Displays the versions numbers of the various parts of software on your Internet radio.
<Upgrade Firmware>
Use this option to download new firmware for the radio from the Reciva portal on the Internet. If
there is new firmware available, then the radio will prompt you if you want to download it or not.
Note, at this stage, you can press the radio's BACK button to cancel the radio beginning a
firmware upgrade A firmware upgrade may take several minutes, so do no switch off the power
to the radio until the operation is complete otherwise the radio may become permanently
damaged.
<Language>
Allows you to change the display language.
<Factory Reset>
Puts all the settings back to their defaults as they were when they left the factory. If you perform
a factory reset on your radio will lose all your presets and your wireless network connection.
8