Operation - Reloop MIXAGEController Edition Bedienungsanleitung

In the selection screen open the mapping file that is found on the CD or that was downloaded from
the Reloop support site.
Troubleshooting
Should a problem arise and Mixage´s LEDs are not lit correctly, this is probably caused in most ca-
ses by installed MIDI software (e.g. MidiYoke, Maple Virtual MIDI Cable, Bome, Osculator, etc.)
In order to solve the problem proceed as follows:
1. In Traktor open the adjustment dialogue by clicking the small cog wheel in the
2. Open the category „Controller Manager".
3. For the following device entries the following port assignments have to be configured:
Device
Mixage V*

4. OPERATION

After connecting and configuring Reloop Mixage correctly for the DJ software, Traktor can now be used.
NOTE!
In the following the whole Traktor function assignment will be described. Some features are only
available in Traktor Pro and therefore they have been marked grey in the following chart.
Element
T1
T2
T3
26
In-Port
Reloop Mixage
Function
Pitch Bend – Button
Allows the temporary deceleration (counter-
clockwise) of a track.
Pitch Bend + Button
Allows the temporary acceleration (clockwise)
of a track.
Shift Button
By pressing this button all the device's con-
trol elements receive a different function. The
current assignment can be viewed on the right
side of this chart.
upper right corner.
Out-Port
Reloop Mixage
Function with activated Shift -T3-