Placing The Speakers - Yamaha soavo-2 Bedienungsanleitung

Place the speakers on a sturdy, vibration-free surface, or on a
well-built stand.
Using as 2ch stereo speakers
Better stereo images will be obtained when the speakers are
slightly angled in towards the listeners.
Using as front speakers in a multi
channel system
Position the speakers on both sides of the TV. The positioning
of speakers is important, because it controls the whole sound
quality of a multi channel system. Set up the speakers on the
basis of your listening position by following the owner's
manual supplied with your amplifier.
Speaker layout image
Soavo-2
Center
Note
Placing this unit too close to a TV set might impair picture
color or create a buzzing noise. Should this happen, move
the speaker away (more than 20 cm (7-7/8")) from the TV
set.
2
En

PLACING THE SPEAKERS

Subwoofer
Surround
Yamaha speaker stand SPS-900 (option)
You can use this unit as a floor stand speaker when
installing on an SPS-900.
In this case, use screw holes on the bottom of this unit.
• For details about installing, refer to the assembly
instruction of SPS-900.
Bottom view
(Front side)
135 mm (5-5/16")
Notes
• To avoid accidents resulting from tripping over loose
speaker cables, fix them to the floor.
• Do not fasten the speaker on the stand with nails or
adhesives, etc. Long time use and vibrations may
cause this unit to fall down.
• Do not pinch the cables between the speaker and the
stand.
Screw holes
Diameter: 4 mm (5/32")
Hole depth: 13 mm (1/2")
Yamaha speaker
stand SPS-900