Herunterladen Inhalt Inhalt Diese Seite drucken

Grundig M 7-C Service Anleitung Seite 12

Inhaltsverzeichnis

Werbung

Allgemeiner Teil / General Section
Fig. 33
a
21. Ausbau der Cassettenlaufwerke (Fig. 33)
- Die Frontblende ausbauen (Pkt. 3).
a
- 4 Schrauben
(lang) herausdrehen.
b
- 4 Schrauben
(kurz) herausdrehen.
- Beide Cassettenfachdeckel durch Drücken der Tasten "Eject" öff-
nen.
- Beide Laufwerke abnehmen.
Fig. 34
22. Auswechseln des A-W-Drehkopfes (Fig. 34 / 35)
- Die Cassettenlaufwerke ausbauen (Pkt. 21).
- Kopfleitungen von der Kopfsteckerplatte (Stecker 1720 Fig. 34)
ablöten, vorher Anschlüsse notieren.
c
- 2 Schrauben
(Fig. 35) herausdrehen und den Tonkopf heraus-
nehmen.
- Neuen Tonkopf einsetzen und in umgekehrter Reihenfolge zusam-
menbauen.
d
e
Die Schrauben
und
(Fig. 35) dienen zur Kopfspaltsenkrecht-
stellung (Azimut) und dürfen nicht festgedreht werden.
Kopfspaltsenkrechtstellung siehe unter Abgleichvorschriften Sei-
te 2 - 2.
Fig. 36
g
23. Ausbau eines Andruckrollenhebels (Fig. 36 / 37)
- Die Cassettenlaufwerke ausbauen (Pkt. 21).
f
- Rastnase
vorsichtig ausrasten und den Andruckrollenhebel
abziehen.
1 - 12
b
b
a
Kopfsteckerplatte
Head Connector Board
f
g
b
b
a
a
21. Removing the Drive Mechanisms (Fig. 33)
- Remove the front panel (para 3).
a
- Unscrew 4 screws
(long).
b
- Unscrew 4 screws
(short).
- Open both cassette compartment lids by pressing the buttons
"Eject".
- Remove both drive mechanisms.
Fig. 35
d
22. Replacing the R-P-Rotary Head (Fig. 34 / 35)
- Remove the drive mechanisms (para 21).
- Unsolder the headleads from the head connector board (connector
1720 Fig. 34). Before this, note down the connections.
c
- Unscrew 2 screws
(Fig. 35) and remove the sound head.
- Fit the new sound head and re-assemble in reverse order.
d
e
The screws
and
(Fig. 35) are provided for adjusting the head
gap (azimuth) and must not be tightened completely.
Adjustment of the head gap, see Adjustments page 2 - 4.
Fig. 37
23. Removing a Pressure Roller Lever (Fig. 36 / 37)
- Remove the drive mechanisms (para 21).
f
- Disengage the locking lug
g
roller lever
.
M 7-C / M 17-C / M 27-C
c
c
e
g
carefully and pull out the pressure
GRUNDIG Service
f

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

M 17-cM27-c

Inhaltsverzeichnis