Description Of The Control Panel; Fault Indicator Lights - Miele Professional WS 5080 Gebrauchsanweisung

Description of the machine
11
11 = Programme sequence indicator lights
Water inlet

Fault indicator lights

A fault or malfunction is indicated by a
flashing indicator light.
Level
Heating
Operation
Water inlet
M.-Nr. 04 506 754
On
Pre-wash
Main wash
Rinse
Starch
Rinse
Without spin*
Spin
End/Door
Fault
Drain
*) rinse-hold
Door
Water outlet
Explanation:
"Level"
Fault in the water level system (water level)
"Heating"
Fault in the heating up system
"Operation"
Operation fault
"Door"
Fault in the locking mechanism. Open the
door manually (see "Power cut during a wash
process").
If one of the fault indicator lights listed above
flashes an approved Service Engineer must
be called to remedy the fault.
"Water inlet"
Indicates an insufficient/inadequate water
supply eg. stopcocks turned off, or water inlet
filters blocked.
"Drain"
The drain outlet from the machine is blocked
or the drain valve is defective.**
After rectifying the fault or error the wash pro-
gramme will need to be started from the be-
ginning again.
**) a defective drain valve should only be re-
paired by an approved Service Engineer.
Only refers to WS 5100 and WS 5140
with gas heating
Fault message "Heating"
The "Heating" indicator light flashes if there is
an interruption to the on-site gas supply to the
machine, for example if the gas stop valve is
not open. If any other lights blink at the same
time, this is of no further significance.
Turn on the gas stop valve. Restart the
machine by first releasing the On-Off button
and then pushing it in again, and pressing the
"Start" button.
If the "Heating" indicator light still flashes after
this, call your Service engineer to remedy the
fault.
41