Detergent Dispensing; Fault Message "Ignition Fault" And "Blocked Filter - Miele Professional WS 5080 Gebrauchsanweisung

Operation

Detergent dispensing

Avoid dispensing more than the required amo-
unt as this can cause excessive foaming.
Use only low lather detergents.
Important: With gas heated machines use
only high quality detergents to avoid the
heater pipe furring up quickly.
Amount dispensed:
Follow the detergent manufacturer's instructi-
ons.
Notes:
Do not fill fabric conditioner or bleaching
agent higher than the level mark in the dis-
penser.
For bleaching at least 4 rinse cycles must be
programmed (see "Re-programming" and the
"Programme changes" chart).
Press the "Start" button in. The "Time"
display will go out and the "Temperature"
display will illuminate.
- the wash programme then progresses.
44
If the "Without Spin" (Rinse hold) button
was pressed the programme will be inter-
rupted after the last rinse. The "Rinse
hold" indicator light will illuminate.
- Washing remains suspended in water.
If washing is to be spun:
Press the "Without spin (Rinse hold)" but-
ton again. The water in the drum will drain
followed by a final spin.
Otherwise:
– - If the programme is to finish without
spinning turn the programme selector
switch to position
Only refers to WS 5100 and WS 5140
with gas heating
Fault message "ignition fault"
If the symbol " y " appears in the time (hrs)
display this indicates an ignition fault.
Wait for at least 1 minute before operating
the "Reset" button to repeat the ignition
process.
If this measure is not successful call your
Service engineer to remedy the fault.
Fault message "blocked filter"
A continuous humming tone during a
wash programme indicates that the fluff fil-
ter needs to be cleaned.
H
(Separate drain).
M.-Nr. 04 506 754