Sauber V10 - CyclonePro Handbuch Seite 23

V10
USE AND FUNCTION
Assembling vacuum cleaner
Note:
Always remove the power plug from the wall outlet before assembling or removing accessories.
1. Attaching the Flexible Hose into the vacuum connect the flexible hose into the air intake duct, push in
until you hear a "click" sound, indicating it is in its locked position.
2. Fitting the tube to the curved wand/hose extension. Push the tube into the curved wand/hose
extension.
3. Fitting the floor brush to the tube. Push the tube into the floor brush. Adjust the tube to the desired
length.
BUTTON FUNCTION INTRODUCTION
Note:
Once all attachments are in place, unwind a sufficient length of cable and insert the plug into the wall outlet.
A yellow mark on the power cord shows the ideal cable length. Do not pull the power cord beyond the red
mark.
1. Insert the power plug into the wall outlet.
2. Press the power on/off button located the unit to turn the vacuum cleaner "on".
3. To rewind the power cord, press the cord rewind button with one hand and guide the power cord with
the other hand to ensure that it does not whip causing damage or injury.
On/off button
Dust barrel release button
Rewind button
Speed control button
EN