Switch On The Robot Vacuum Cleaner; Connect The Base Station; Charge The Rechargeable Battery - Miele Scout RX1 Gebrauchsanweisung

Switch on the robot vacuum cleaner

(dia. 4)
^ Press the ON switch on the side of
the robot vacuum cleaner.
The rechargeable battery status and
the Auto standard vacuuming mode
indicators will light up in the display.
After approx. 60 seconds the robot
vacuum cleaner will switch into
standby. The battery status indicator
will continue to light up.
The robot vacuum cleaner is
reactivated by pressing any button on
the remote control or one of the two
sensors in the robot vacuum cleaner
display.
Connect the base station (dia. 5 - 9)
^ Open the storage compartment at the
back of the base station (dia. 5).
^ Insert the power unit connector
supplied into the socket at the top of
the storage compartment (dia. 6)
^ Connect the mains connection cable
supplied to the power supply unit
and the mains plug to an electrical
socket (dia. 7). The contact indicator
on the base station will light up red.
^ Stow the power supply unit in the
storage compartment in the base
station and feed the mains connecti-
on cable through the slot (dia. 8).
^ Place the base station on a level
surface against a free wall. Ensure
that there is an obstacle free distance
of at least 1.5 m in front and 0.5 m to
the right and left of the base station
(dia. 9).

Charge the rechargeable battery

(dia. 10)
The rechargeable battery is supplied
not fully charged. It needs to be
charged fully before first use.
The battery can also be charged
when the robot vacuum cleaner is
switched off (OFF switch). In this
case, the vacuum cleaner indicators
will not react.
^ Connect the robot vacuum cleaner
correctly to the charging contacts on
the base station.
Do not lift the robot vacuum cleaner
by the area around the dust box as
it can come loose.
The base station contact indicator will
go out as soon as the robot vacuum
cleaner has been positioned correctly.
The battery will charge and the battery
status indicator will flash in the display.
The charging process takes up to 120
minutes and is complete when the
battery status indicator in the display
lights up green. You can then vacuum
for up to two hours.
You can also charge the battery without
using the base station directly via the
power supply unit.
^ Insert the power supply unit
connector into the socket on the side
of the robot vacuum cleaner (dia. 11).
^ Connect the mains connection cable
to the power supply unit and the
mains plug to an electrical socket
(dia. 7).
en
39