After Sales Service; Guarantee: U.k; Guarantee: Other Countries; Electrical Connection For The Uk - Miele Scout RX1 Gebrauchsanweisung

en
F 5 "Brushes overloaded"
Check whether the roller brush
and the side brushes have
become dirty. Clean the roller
brush and the side brushes.
F 6 "Motor overloaded"
Empty and clean the dust box.
Replace the exhaust filter.
F 7 "Internal system fault"
Switch the robot vacuum cleaner
off and then back on again (press
the ON/OFF switch on the side).
F 8 "Front wheel dirty"
Check the front wheel for debris.
Remove any threads and hair and
clean the front wheel.

After sales service

In the event of a fault that you cannot
easily remedy, please contact
– your Miele Dealer
or
– Miele (see end of booklet for contact
details)

Guarantee: U.K.

In the U.K. the appliance is guaranteed
for 2 years from the date of purchase.
However, you must activate your cover
by calling 0330 160 6640 or registering
online at www.miele.co.uk.

Guarantee: Other countries

For information on the appliance
guarantee specific to your country
please contact Miele. See end of
booklet for contact details.
52
Electrical connection for the
UK
All electrical work should be carried out
by a suitably qualified and competent
person in strict accordance with current
national and local safety regulations
(BS 7671 in the UK).
The voltage and frequency are given on
the data plate located underneath the
vacuum cleaner. Please ensure that
these match the household mains
supply. The fuse rating is quoted on the
plug.
The appliance is supplied with a cable
and moulded plug ready for connection
to a 230-240 V/50 Hz a.c. single phase
supply.
Non-rewireable plugs BS 1363
The fuse cover must be re-fitted when
changing the fuse, and if the fuse cover
is lost the plug must not be used until a
suitable replacement is obtained. The
colour of the correct replacement cover
is that of the coloured insert in the base
of the plug, or the colour that is
embossed in words on the base of the
plug, (as applicable to the design of
plug fitted).
Replacement fuses should be ASTA
approved to BS1362 and have the
correct rating. Replacement fuses and
fuse covers may be purchased from
your local electrical supplier.